accrd94ex
12/30/2007 5:12:37 PM
Ok guys, I am wondering if any one knows some good cams and intake manifold/s for the f22b1 (the ex motor for those whom don't know) I found some cams and a manifold at i think it is f22parts.com but i don't know it they will work good or not and if some one knows a better place to get them because i want to be different and build this motor and not just put a h22a in please give some advice
honda97valdeez
12/30/2007 5:57:56 PM
Nice avatar!
I don't have an answer for you, but be sure to look into the engine management computers or E-Prom chips ($$). I was looking to stroke the v6, then found out the cost of the chip and programming=too much sum total. It would have been cool to have the car stroked and then dyno'd tho. I found a place in tampa (on the internet) and still might visit them and have the car tested for the fun of it.
Good Luck!
BlkCurrantKord
12/30/2007 8:38:26 PM
www.bisimoto.com I wouldn't recomend F22 parts. They haven't even tested most of their products.
GT03 TJS
1/13/2008 5:36:55 PM
you could always do what I did and find yourself a JDM F22B dohc non-vtec (jdm prelude si motor...same as usdm h23 basically)
twin cam f22 thats definetly faster than your stock motor (160 crank hp)....plus being that all the top-end components are interchangeable between the dohc f22b and the h23....a lot more parts become a lot easier to find....
look at crower cams (for h23)...they have a few really good options as well as a new strengthened valvetrain kit.
plus...people always look at you kinda weird when you can say "yeah...its a DOHC non-vtec F22...kinda rare..."
