would a .5 inch drop make ANY difference in my tire wear without camber kit?
All Forums
»
Suspension
»
would a .5 inch drop make ANY difference in my tire wear without camber kit?
thunder_x
11/27/2006 5:31:02 PM
i found these sprint camber kits online for 150 and they are able to support only up to a 1.5 inch drop, but i am planning to drop my car 2 inches
would that .5 difference actually show up in my tire wear, acceleration, or anything else in a negative way?
sir_nasty
11/27/2006 5:46:03 PM
if you were to go from a stock height to .5 inches lower you MIGHT see a very minor amount of adjustment. However, due to angles etc a .5 inch drop from 1.5 inches to 2 inches might be a bigger difference. Either way you'll probably want a camber kit just to be safe, you could however run for a while with that camber as long as you rotate your tires frequently (6 months is the most I'd go) but in the end even if you're only doing 1.5" lower you should get a camber kit.
live2rice
11/27/2006 6:07:39 PM
I wish my car had a camber kit, i lowered it 1.8 inches, and i get a good amount of uneven wear. I have also ripped out a few inner fenders(1.8drop +18s=problems). My wheels also hit the fenders when going over speed bumps and such, so you are going to want to take into consideration what size rim you want when deciding on how low to drop it.
thunder_x
11/27/2006 7:03:01 PM
well, im not going from 1.5 to 2.0
im going from a stock height on my 91 accord with a 2 inch drop and camber kits that can only support a 1.5 inch drop
would there be very minor affects on my tires and ect?
or would it be enough that i would need a better camber kit to support my 2 inch drop?
live2rice
11/27/2006 7:06:23 PM
i would just get ones that can support 2in, do it right, do it once.
sir_nasty
11/27/2006 7:15:59 PM
I would agree that doing it once the first time is the best way to go however I would imagine that this is a kit you are looking at... what I'm curious about is that most camber kits say they can do like +/- 3 degrees and rate them on those basis not on a lowering setup since cars differ so much. With that in mind realize that +/- 1 degree is considered ok by most standards so effectivly if you were adjusted to proper camber at 1.5" drop then went another .5" you should be ok (no optimal for daily driving but ok none the less). There is of course no way to guarantee any of this for sure since so many different factors can come in to play like how the kit works, tire width etc but from what I've seen/experienced you should be ok.... Anyone else agree with this?
thunder_x
11/27/2006 7:16:43 PM
yea...
but the thing is that those are double the price of the sprint camber kits
its like...
a 2 inch drop minus 1.5 inches because of the camber kit...
so my camber would still be negative, but only as if i lowered my car .5 inches, right?
thunder_x
11/27/2006 7:30:13 PM
sir_nasty
11/27/2006 7:32:23 PM
lowering from stock height .5" vs. lowering from normal camber at 1.5" is a bit different because of the angle the suspension components are at from the starting point.... What price range are you looking at for the camber kit? perhaps we could just help you find something that will fit what you need for the same price.
sir_nasty
11/27/2006 7:34:26 PM
so basically you're looking at $300.00 for the front and rear... and it appears that those only adjust for +/- 2 degrees which is why you may have that limitation
thunder_x
11/27/2006 7:37:14 PM
well, i wouldnt pay more than 160 for a set of camber kits
but the thing you said about the angle of the suspension...
so lowering my car 2.0 inches with a camber kit that supports 1.5 vs just lowering my car .5 without the camber kit
which one would be worse for my tire wear and ect.
sir_nasty
11/27/2006 7:40:56 PM
based on what I know lowering it the way you are talking vs. lowering .5" from stock is a bit worse, how much worse I'm not 100% sure. However I just wanted to make sure you see that the camber kit you are looking at is only for a set of 2, so you still need something to adjust the rear
thunder_x
11/27/2006 7:41:39 PM
well, actually
that kit in my link is for both front and back
sir_nasty
11/27/2006 7:48:43 PM
here's a FAQ from ingalls about camber, ingalss makes ball joints for about $160 (front only) that will do +3 degrees change
http://www.ingallseng.com/faq.htm Also, Take note under the description section of that post this is what it says. Double check with the guys before you buy them because it would appear that you're looking at a set of two. I've been wrong before though!
"Do camber kits come in sets of 4?
No, unless otherwise noted, camber kits are sold in sets of 2, so you buy one set for the front and/or one set for the rear."
I do see the seperation though from "Complete Kit" vs. "front or rear" but you may want to take note that the front kit is about $75.00 and the rear kit is about $65.00 so if you buy them seperatly it's $140.00 vs. $151.00 for the kit....
thunder_x
11/27/2006 10:24:37 PM
thanks for the site, but they dont any for my car
91 accord
sir_nasty
11/28/2006 12:58:47 PM
I was more posting the faq because the referance how camber will affect a 92 accord (same as yours) and how it works (kind of) so I listed it for referance more than anything
thunder_x
11/28/2006 5:38:33 PM
oh
[ View Full Version Of This Page ]