i've had my honda for about 11 months its a 98 ex coupe 4cyl. It's 17k kilometers, and the maintain light is on. It turns up few months ago. Does anyone kows how to turn off the maintain light?
there is a little slot to the left of the light/odometer, just put the key in there and it should reset (you may have to hold it down for a few seconds)
_____________________________
1981 Civic Station Wagon - ROhnda (Really Old Honda) 1981 Honda CB650 Motorcylce - WHEE What More can I say? 2000 Lexus RX 300 - Oooh baby my wife let me drive it once!! Quote: Life''''s great but it''''s not all beer and skittles
there is a little slot to the left of the light/odometer, just put the key in there and it should reset (you may have to hold it down for a few seconds)
Not for '98...
Turn off the car. Press & hold the odometer reset button while you turn on the key (no need to actually start the engine). Continue holding that button for maybe 20 seconds more. Maint. lamp will flash & then turn off. Done for another 7500 miles.
Busy with my daughter's car. One tie-rod end balljoint separated on her... In Belden Village parking lot. (I hope she knows how lucky she wasn't driving...) Then I changed her timing belt too.
Thats wild as H--L Jim, mine broke out in the parking lot at Portage and Frank ave over by the Speedy Gas . I was coming back from the airport after taking my wife to Akron Canton when Bamm it fell right out..had to tow it to the shop.. Funny story..happend to you and happend to me in BeldinVillage shopping area.. By the way, do you have a brother named John Blake also?
WheelBrokerAng
_____________________________
" Prejudice Saves Time ; It Enables Us To Form Opinions Without Facts "
By the way, do you have a brother named John Blake also?
No. There's lots of Blake listings in the Canton phone book, I'm not related to any of them!
ps... Yours came apart in a parking lot too? Lucky.
The towtruck driver told my daughter he recently towed someone who's tie rod came apart while they were driving on the highway. That could have had a really bad ending...
< Message edited by JimBlake -- 1/8/2007 10:22:07 AM >
Printable Version
Help - 
