Intake Manifold
 

So my next project is gonna be a new intake manifold. Going from an f22 to f23 intake manifold. They're not too expensive if they come off stock f23s. I'm wondering if thats fine- then I could even go to a U-Pull-it and get it myself and clean it up, or would it be best to buy a performance one?
I'm not looking to put too much into my car right now, just seeing what I can do to increase the performance and make it run well, is a stock f23 intake good enough?
And what should I look for with it to make the installation much easier?

DIY F23 Intake Manifold Swap (F22B)

searching is your friend ;)

Thanks, I found this before. I did look around quite a bit, but its always nice to get a forward answer from a forward question leaving very little room for error.

I feel ya just do your research be4 doing anything. It's well worth it

Thats what I'm doing. Any question I ask on here I've been looking all over online beforehand. In the end I enjoy asking a person any specifics and getting a second opinion.

it's all good. ask away! I just get on ppl for not searching cus 99% of the stuff is right at your fingertips and ppl can't take the 5min search