f23 engine block?...Do you have it?

 

Yes I have complete engine with harness but no trans shipping to Florida will be very expensive

 

The third brake light harness is also taped into the rest of te harness that goes to the fuel pump and rest of the tail lights if u want I can cut of maybe like 8" or so. So u could make your own pigtail to your tail lights.. Ill post the headlights and rubber trim in a few minutes.

 

Here are the pics I promised..
Drivers Headlight No Scratches No Broken Tabs and all bulbs included



Drivers door inside rubber trim All tabs in excellent condition

 

could you post a pic of the trunk where that wire is gonna be? is you honda 2 door of four door?

 

It's a 4dr , the wire will be cut right where it enters the harness so all you need to do is splice the tail light wires I'll post a pic in a few

 

So in this picture you can see the wire from the bulb.

Now this picture shows that I can cut the wire as close to the harness and you can tap the wire into the tailight which is also in the harness.

This will most likely be the best way instead of replacing the entire harnes from the front of the vehicle back.

 

I would only want the engine block anyways. It would only be around $130 to ship with ups. Iv shipped trannys with them be4

 

Id rather not take apart a good running engine. It has only 64,009 miles so Im going to try to sell it locally or if you want the whole motor thats fine too lmk

 

is that the lowest price you can give me?