AnzoUSA Projector Cutoff
Thread Starter
|
Junior Member
Joined: Feb 2009
Posts: 17
AnzoUSA Projector Cutoff
Cutoff 1:http://s47.photobucket.com/albums/f1...Picture003.jpg
Cutoff 2:
http://s47.photobucket.com/albums/f1...Picture004.jpg
Cutoff 3:
http://s47.photobucket.com/albums/f1...Picture017.jpg
sorry about the graffiti. What do you guys think?
Last edited by WHATTHELOUIS; Feb 3, 2009 at 12:09 PM.
Been Around A Long Time Member
Joined: Jun 2007
Posts: 7,381
From: St. Paul, MN
It's very poor compared to OEM projectors, but about the best you can do for the money. Proper projector aiming the cutoff should be 2" below the centerline of the projector at like 25' away. Looks like yours is a bit too high.
At least the driver side is nice and level, that's the most important so you don't blind people too much.
At least the driver side is nice and level, that's the most important so you don't blind people too much.
Thread Starter
|
Junior Member
Joined: Feb 2009
Posts: 17
which cutoff line exactly lol?
as you can tell they both (left and right) flare up a bit to the right.
is there anything i can do to fix the flaring on the right?
i don't get flashed by oncoming drivers or other cars going my way...
as you can tell they both (left and right) flare up a bit to the right.
is there anything i can do to fix the flaring on the right?
i don't get flashed by oncoming drivers or other cars going my way...
Been Around A Long Time Member
Joined: Jun 2007
Posts: 7,381
From: St. Paul, MN
You would have to open them up and rotate the projectors.
Both cutoffs should be 2" below the centerline of the projectors. Measure the height of the projector lens at the car, park the car 25" from a wall and shine the lights on it. Subtract 2" from your measurement and that's where the projector cutoff should hit.
Both cutoffs should be 2" below the centerline of the projectors. Measure the height of the projector lens at the car, park the car 25" from a wall and shine the lights on it. Subtract 2" from your measurement and that's where the projector cutoff should hit.
Thread Starter
|
Junior Member
Joined: Feb 2009
Posts: 17
You would have to open them up and rotate the projectors.
Both cutoffs should be 2" below the centerline of the projectors. Measure the height of the projector lens at the car, park the car 25" from a wall and shine the lights on it. Subtract 2" from your measurement and that's where the projector cutoff should hit.
Both cutoffs should be 2" below the centerline of the projectors. Measure the height of the projector lens at the car, park the car 25" from a wall and shine the lights on it. Subtract 2" from your measurement and that's where the projector cutoff should hit.
Thread
Thread Starter
Forum
Replies
Last Post
