EZ Lip installed on my 07 Accord
#11
So I got the newest EZ Lip, EZ Lip Pro... It's bigger than the last one. Just wanted to show everyone how it looks in case you're like me and need to see it on your car before doing anything. So same instructions as last time, warm the tape with a heat gun or blow dryer (it doesn't need much), do it on a hot day, and push it on tightly, one small section at a time. You'll notice I screwed it in at the ends but that's only because on this bumper, I wanted that look where it curves up, virtually no tape or glue will hold that look, so I just made a small hole with a drill, picked a washer & screw & it was done in minutes. I don't care if there's a hole in the bumper, by the way, it's where nobody can see it anyway...
Thread
Thread Starter
Forum
Replies
Last Post
MikeT
Appearance
4
07-18-2011 04:17 PM
chenghng
Appearance
0
11-28-2006 11:56 PM
aso432
Engine & Internal
1
10-23-2005 10:41 PM