i have to get my rotors resurfaced/replaced, which place will be the best for this job

thanks

 

Your garage with tools and a case of beer.

 

replace them youself, very easy job,, rotors over hubs ,, there is a write up in our DIY section

 

Brembo blanks FTMFW and the best bang for your buck. While your in there, I'd recommend some Hawk HPS pads too.

 

Cost of resurfacing is too large a fraction of new rotors. Unless you are a hard braker, the inexpensive replacement rotors (Made in China) are adequate.

good luck

 

Take them to advance Auto and have them mike them to see if theres anything left of them to turn..

WheelBrokerAng [sm=americanasmiley.gif]

 

^^^ IMO, not worth it. Just swap them out.

 

Brembo makes a great oem rotor like Falkore24 stated for a good price and you can get better pads with out the risk of warpping the rotors. The china ones are very cheap in price but you will warp them if you brake hard. Just my opinion but brakes are not a part of the car you want to cut corners on.