General Tech Help Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

idling problems

Old Mar 12, 2015 | 07:02 PM
  #1  
2yoing2drive's Avatar
Thread Starter
Joined: Mar 2015
Posts: 3
Default idling problems

Car is 1999 accord with 2.3 and automatic. 230,000 miles.

Two weeks ago I replaced the thermostat due to it sticking open. And I replaced the temperature gauge sensor at the same time.

Immediately after the car had a lowered idle. It's progressively gotten worse and now the car idles at around 100 rpms. It has never done this until I switched the thermostat and sensor.

Distributor cap, rotor, wires and plugs are brand new. I just ordered a new iacv just in case. Any tips would be appreciated.
 
Old Mar 12, 2015 | 08:52 PM
  #2  
shipo's Avatar
Super Moderator
Joined: Aug 2012
Posts: 3,070
From: Southern New Hampshire
Default

My advice would be to stop throwing parts at the problem and have it professionally diagnosed; it'll probably cost you less in the end.
 
Old Mar 12, 2015 | 10:24 PM
  #3  
PAhonda's Avatar
Super Moderator
Joined: Sep 2006
Posts: 16,331
From: Houston, TX
Default

Did you go with aftermarket parts? Do you still have the old sensor?
 
Old Mar 13, 2015 | 04:36 AM
  #4  
2yoing2drive's Avatar
Thread Starter
Joined: Mar 2015
Posts: 3
Default

These parts weren't thrown at it. It needed all of them.

This is my back and forth car. If this problem didn't make the car so undriveable it wouldn't bother me
 

Last edited by 2yoing2drive; Mar 13, 2015 at 04:40 AM.
Old Mar 13, 2015 | 04:38 AM
  #5  
2yoing2drive's Avatar
Thread Starter
Joined: Mar 2015
Posts: 3
Default

I'd have to look for the old sensor. I will try switching it back. The new parts are NOT a Honda part.
 

Last edited by 2yoing2drive; Mar 13, 2015 at 05:35 AM.
Old Mar 13, 2015 | 09:09 AM
  #6  
TexasHonda's Avatar
Super Moderator : And A Texan
Joined: Feb 2007
Posts: 9,652
From: Katy, TX
Default

Is Check Engine Light On? You don't say but this is fastest way to begin diagnosis,..obtain the codes and post them here.

Idle speed is controlled by the idle air control valve (IACV). Suggest unplugging and checking whether idle changes. If no change, the IACV is not functioning. If no code for faulty IACV, then valve is likely blocked w/ dirt/grease. Clean check function w/ 12V directly applied to IACV connection.

good luck
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
07AccordCp
General Tech Help
21
Jul 18, 2013 11:49 AM
Stampcop
General Tech Help
3
Apr 9, 2012 07:48 PM
94Honda
Engine & Internal
43
Dec 22, 2007 01:26 AM
brokenspoke
General Tech Help
3
May 23, 2006 04:11 AM
KimberlyC
General Tech Help
4
Apr 16, 2006 11:51 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 04:00 PM.