DIY Injen CAI on 1995 Accord
#1
DIY Injen CAI on 1995 Accord
I am attempting to install an Injen cold air intake on my 1995 Accord EX V-tech, but there are a few steps that I am unsure of, mainly where you have to cut a hose and then t-line it. Has anyone done this on theirs and could give me a better idea then these directions do, and/or take a picture of what yours looks like? Thanks!
Last edited by calike; 05-15-2012 at 03:57 AM. Reason: forgot to tell what model
#3
Don't know what you are talking about.
Mine went in very easily.
I did end up capping the vacuum going to the valve cover as it was too strong and I just put a small filter on the valve cover instead.
I got mine for free I hope you didn't pay anything for yours as they are only good for 0-2 HP.
Mine went in very easily.
I did end up capping the vacuum going to the valve cover as it was too strong and I just put a small filter on the valve cover instead.
I got mine for free I hope you didn't pay anything for yours as they are only good for 0-2 HP.
#4
don't know what you are talking about.
Mine went in very easily.
I did end up capping the vacuum going to the valve cover as it was too strong and i just put a small filter on the valve cover instead.
I got mine for free i hope you didn't pay anything for yours as they are only good for 0-2 hp.
Mine went in very easily.
I did end up capping the vacuum going to the valve cover as it was too strong and i just put a small filter on the valve cover instead.
I got mine for free i hope you didn't pay anything for yours as they are only good for 0-2 hp.
hahaha! Awesome!!
Thread
Thread Starter
Forum
Replies
Last Post
jasonfridlund
Headers, Intake, & Exhaust
4
06-24-2009 02:37 PM