No power to ignition after installation
#1
No power to ignition after installation
My son's 1995 4D TM Honda Accord was stolen recently. The ignition was rammed then tore apart. We just replaced the entire ignition assembly including all harness'. We found video instructions on how to install and think we did a good job. But now we have absolutely no power comming to the ignition or the entire dash after reconnection the ground cable at the battery. What have we missed? Might there have been a different cable cut when it was stolen that we are not seeing. Please help.
Thanx, George.
Thanx, George.
#2
Suggest downloading the 94-97 Accord manual from Online Manuals post in DIY forum. This will have wiring diagram to allow you to trace power and ground connections.
It's possible they cut wires after trying to jump ignition switch assy.
good luck
It's possible they cut wires after trying to jump ignition switch assy.
good luck
Thread
Thread Starter
Forum
Replies
Last Post
thunder_x
Headers, Intake, & Exhaust
7
05-01-2007 03:36 PM