1994 EX---What is this sensor and will it let the car run?

Reply Subscribe

Thread Tools

Search this Thread

Jul 17, 2013 | 11:34 AM

#11

JimBlake

Super Moderator

Joined: May 2006

Posts: 18,398

From: Wisconsin

Crimp-on butt connector should work OK. You might want to use heat-shrink tubing over that, to make it a bit more water-resistant.

Jul 17, 2013 | 11:37 AM

#12

faran

Thread Starter

Almost A Senior Member

Joined: Jan 2013

Posts: 288

Perfect, something similar to this one??:

10 Pack 10-12 Gauge Watertight Heat-Shrink Butt Connectors

http://www.harborfreight.com/catalog...utt+connectors

Last edited by faran; Jul 17, 2013 at 11:39 AM.

Jul 18, 2013 | 11:46 AM

#13

JimBlake

Super Moderator

Joined: May 2006

Posts: 18,398

From: Wisconsin

I haven't seen the kind that are waterproof all by themselves, but it sounds good.

Jul 18, 2013 | 08:44 PM

#14

faran

Thread Starter

Almost A Senior Member

Joined: Jan 2013

Posts: 288

Cool, gonna follow the advice and use butt connector on the wire splice.

Thanks again guys for all of your help, patience and cooperation while I fix this POS

Jul 19, 2013 | 10:28 AM

#15

JimBlake

Super Moderator

Joined: May 2006

Posts: 18,398

From: Wisconsin

get it all fixed up so it's not a POS any more...

Jul 21, 2013 | 11:45 AM

#16

faran

Thread Starter

Almost A Senior Member

Joined: Jan 2013

Posts: 288

Final update, I pulled the sensor from the junkyard yesterday, along with the heat resistant tubing over it.

Electrical taped it and wrapped the tubing over it.

So far no issue and no CEL. If issue arise in the coming days, will definitely use Crimp-on butt connectors and then wrap the tubing over it.

Thanks again for the help guys, really appreciate your patience, help and cooperation