misfires - NO check engine light
Unregistered
Posts: n/a
misfires - NO check engine light
hi,
misfires even at low speeds - NO check engine light!
new plugs, wires, cap, rotor, ignition coil. honda adjusted timing and valves.
still misses after 2 miles of driving????
bad distributor?
bad ignition module?
misfires even at low speeds - NO check engine light!
new plugs, wires, cap, rotor, ignition coil. honda adjusted timing and valves.
still misses after 2 miles of driving????
bad distributor?
bad ignition module?
Junior Member
Joined: Mar 2009
Posts: 8
I had the same problem, put a new set of plug wires, still had the problem, got to looking at the wires really good, and found that one of the wires was going to ground inside the head, below the boot, so you couldn't see it when the engine was running.
The were brand new wires from auto zone.
The were brand new wires from auto zone.
Unregistered
Posts: n/a
I had the same problem, put a new set of plug wires, still had the problem, got to looking at the wires really good, and found that one of the wires was going to ground inside the head, below the boot, so you couldn't see it when the engine was running.
The were brand new wires from auto zone.
The were brand new wires from auto zone.
good suggestion - i'll do a good visual inspection. the only ignition component i haven't replaced is the ignition module - your thoughts?
rwarrer
Thread
Thread Starter
Forum
Replies
Last Post
2001SCAccord
General Tech Help
5
Sep 10, 2010 04:15 PM
78gaw
General Tech Help
11
Jan 20, 2010 09:45 AM
