1994 Accord irratic idle
Super Moderator
Joined: May 2010
Posts: 11,834
From: Kenton, TN
Me,
Car is off and cold.
Open the bleeder - or remove all the way.
Turn the heat to max.
Fill or top of rad (SLOWLY) until coolant comes out of the bleeder at a good pace.
Replace bleeder and or tighten.
Put rad cap on - ONLY to first click.
Start car and let is run until fans cycle.....ok I might shorten this in the cold to ~20 minutes.
Remove cap and check level. Add if needed.
Be sure to check the level in the overflow as well.
Car is off and cold.
Open the bleeder - or remove all the way.
Turn the heat to max.
Fill or top of rad (SLOWLY) until coolant comes out of the bleeder at a good pace.
Replace bleeder and or tighten.
Put rad cap on - ONLY to first click.
Start car and let is run until fans cycle.....ok I might shorten this in the cold to ~20 minutes.
Remove cap and check level. Add if needed.
Be sure to check the level in the overflow as well.
Thread Starter
|
Newest Of Newbies
Joined: Jan 2013
Posts: 17
I replaced thermostat;re-bled system again(third time).Guage @ 4 o'clock ;very good heat think we have it repaired;time will tell
Thanks for help
Thought I would pass this on.My local Carquest wanted$25.79 for Stat and gasket;told them to keep it; went to Murray's came to $10.49 pays to shop around
Thanks for help
Thought I would pass this on.My local Carquest wanted$25.79 for Stat and gasket;told them to keep it; went to Murray's came to $10.49 pays to shop around
Thread
Thread Starter
Forum
Replies
Last Post
darryltravis
General Tech Help
6
Apr 25, 2006 01:26 AM
