General Tech Help Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

90 accord lx dieng problem

Old Apr 3, 2012 | 10:37 PM
  #1  
Josh McClure's Avatar
Thread Starter
Joined: Apr 2012
Posts: 3
Exclamation 90 accord lx dieng problem

i have a 90 honda accord lx 2.2 4cl 16 v . with an f22a1 motor and an AT tranny

for the past month it will run fine until randomly dies out of nowhere and sometimes on the highway. and after i sit for a few mins it will restart but then die on the take off , or dies when ive gotten up to speed for about ten seconds

ive read the codes and its throwing code 15 which is the ignition output signal . ive replaced the tps, vss, main relay , and also has a new distributer with new wires and plugs
ive read on here that its the ignition modual but i dont see how with a new ditributer in place

if someone can please help , please give me advice im desprate to know whats goin on ive put way to much money in this car to let it go
 
Old Apr 3, 2012 | 10:42 PM
  #2  
PAhonda's Avatar
Super Moderator
Joined: Sep 2006
Posts: 16,331
From: Houston, TX
Default

Did the new distributor come with a new ignition module?
 
Old Apr 3, 2012 | 10:43 PM
  #3  
Josh McClure's Avatar
Thread Starter
Joined: Apr 2012
Posts: 3
Default

yes it did . the whole thing was new
 
Old Apr 3, 2012 | 11:03 PM
  #4  
PAhonda's Avatar
Super Moderator
Joined: Sep 2006
Posts: 16,331
From: Houston, TX
Default

When the engine is running, try shaking the key. Does the engine stall out?

There is a ground wire bolted to the thermostat housing that is important. I would unbolt it and clean the bolt and eyelet with a wire brush.
 
Old Apr 4, 2012 | 07:17 PM
  #5  
Josh McClure's Avatar
Thread Starter
Joined: Apr 2012
Posts: 3
Default

no the it doesnt stall when i wiggle the key . and i cleaned it off but didnt it again today
 
Old Apr 6, 2012 | 03:32 PM
  #6  
poorman212's Avatar
Super Moderator
Joined: May 2010
Posts: 11,834
From: Kenton, TN
Default

Sorry, I'm confused.

Is the car still acting up?

Are you getting the same code?

Did you clear the code?
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trouble
General Tech Help
3
Aug 21, 2012 07:46 PM
jkrueger2020
General Tech Help
8
Mar 10, 2011 02:18 AM
kellysa111
General Tech Help
4
May 1, 2009 08:35 AM
mahones
General Tech Help
3
Oct 13, 2008 08:24 AM
92Inspire
General Tech Help
14
Aug 13, 2006 03:37 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 02:38 AM.